Skip to main content

Commercial Flooring

Flooring for Offices: What to Specify and Why

14 September 2026 · 6 min read

Commercial carpet tile in a Melbourne open-plan office

Noise, chair wear and downtime decide an office floor — not appearance. What to specify for open-plan, cellular and cabled offices, and what it costs to keep.

Most office flooring decisions get made on a photograph. Then the floor goes in, and within a year the complaints are about noise in the open-plan area, worn patches under the desks, and the fact that lifting one damaged section means replacing a whole run.

None of those are appearance problems. Here is what a facilities manager or fit-out designer should actually be specifying, and why.

The three things that actually decide it#

Noise. An open-plan office is loud, and flooring is the largest single surface available to absorb sound. Get this wrong and no amount of acoustic panelling afterwards fully fixes it.

Chair wear. A task chair on castors does more damage to a floor in twelve months than foot traffic does in five years. It is concentrated in a small area under every desk, which is exactly where it shows.

Downtime. A floor that closes a working floor for three days costs three days of productivity, and that frequently dwarfs the price difference between two products.

Everything else — colour, finish, plank format — matters, but it matters after those three.

Noise: the complaint that arrives six months later#

Carpet is the most effective sound absorber available in a fit-out. That is the main reason commercial carpet still dominates corporate offices despite hard floors being fashionable everywhere else.

It works in two ways. It absorbs airborne sound — voices, phone calls, keyboards — and it stops impact sound, the footfall that travels to the floor below. In a multi-tenant building the second one is often a lease requirement rather than a preference.

If a hard floor is wanted for appearance, acoustic-backed commercial vinyl is the usual compromise. An acoustic backing is a resilient layer bonded to the underside of the plank or sheet, and it makes a measurable difference to impact sound. Vinyl without it, over a concrete slab, in an open-plan floor, is the specification we most often see regretted.

Ask for the acoustic rating in writing. It is expressed as a decibel reduction figure, and a supplier who cannot give you one for a commercial product is not the right supplier.

Chair castors do the real damage#

This is the failure nobody predicts from a sample.

A hard castor rolling over the same square metre thousands of times abrades the wear layer faster than any amount of walking. On carpet it crushes and flattens the pile. On vinyl it polishes and eventually cuts through the clear layer.

Three practical answers:

  • Specify a wear layer rated for commercial traffic, and set it by the busiest area rather than the average. An office is not uniform — the desks and the main circulation route do most of the work.
  • Use soft castors. Standard hard castors on a soft floor are a mismatch; they are cheap to change and most people never think of it.
  • Choose a format you can replace. Carpet tiles are the honest winner here: a worn tile lifts out and a new one goes in. Broadloom means replacing a run and trying to match a dye lot from two years ago.

Buying spare boxes at the start is normal commercial practice, and it is what turns a worn patch into a ten-minute job.

Cabling and access floors#

If power and data run under a raised access floor, this decision is already mostly made.

Carpet tiles let you lift a square, reach the service, and put it back. Broadloom over an access floor largely defeats the point of having one — and offices get re-cabled far more often than they get re-floored.

Even without an access floor, modular formats matter for cabling. Desk positions move. Power points get added. A floor you can open in one square metre is worth more over ten years than a floor that photographs slightly better on day one.

Room by room through a fit-out#

Open-plan floor. Carpet tiles, or acoustic-backed vinyl if a hard surface is wanted. Traffic rating set by the main circulation route.

Cellular offices and meeting rooms. Quieter, so the traffic rating can drop and the acoustic requirement is lower. This is where a nicer product can go without paying for it across the whole floor.

Reception. The one area where appearance genuinely leads — it is the first thing a visitor sees. Hard flooring reads as more considered here, and the area is small enough that a better product is affordable. Entry matting is not optional: wet shoes on a hard reception floor is both a slip risk and the fastest way to wear it.

Corridors and circulation. The busiest flooring in the building and the most often under-specified, because it is nobody's favourite part of the plan. Rate it highest, not lowest.

Kitchen and breakout. Spills, constant chair movement, food. Something waterproof and easy to clean, and worth treating as a separate zone rather than continuing the office floor into it.

Server and comms rooms. Anti-static specification, which is a genuine technical requirement rather than a nicety.

Installing around people who are still working#

Most Melbourne office jobs are not empty-building jobs. Someone is working while the floor goes down, and that shapes the specification more than people expect.

Modular formats win on this alone. Carpet tiles and loose-lay vinyl can be laid section by section, out of hours, without closing the floor. Sheet vinyl needs welding and curing time, and glued broadloom needs the area vacated.

Two things to settle before anything is ordered: who moves the furniture, which is a real cost that gets left out of quotes, and what happens at the thresholds between old and new flooring, which is where commercial floors fail first.

What it costs to keep#

The quote you compare is supply and installation. The number that decides the true cost is the next ten years.

Ask these before signing:

  1. How is it cleaned, and how often? A floor needing a specialist machine or a stripping-and-resealing cycle carries an annual cost your cleaner will bill you for.
  2. Can one damaged section be replaced? Tiles yes. Sheet and broadloom need a patch, and the patch usually shows.
  3. What voids the warranty? Steam cleaning voids more commercial warranties than anything else, and it is the first thing a new cleaning contractor reaches for.
  4. Are spares held? A box of spare tiles on a shelf is the cheapest insurance in the building.

For a wider comparison of the materials themselves, our guide to the best flooring options for commercial places covers vinyl, carpet, hybrid, laminate and polished concrete side by side, and our commercial flooring page shows what we supply and install across Melbourne.

Fitting out an office? Tell us the floor area, the traffic and your timeframe, and we will recommend a specification and give you a firm price.

Free, no-obligation quote

Get your free flooring quote

Tell us the rooms and roughly the area. We measure, bring samples, and send a fixed quote — usually back within one business day.

Prefer to talk? Call 0475 588 816 · No spam, ever.